Epygi Technologies Release Note QuadroM32x 5.3.53 Edition 1
FindMe/FollowMe enabled 15942
Will be fixed in the next releases.
After changing Quadro LAN IP configuration (IP address or subnet mask) IP
phones lose registration and become unusable 16037
After changing Quadro LAN IP configuration first reboot the Quadro then reboot
the IP phones. Will be fixed in the next release.
MAC address recognition problem in the FXS Gateway Management" page 16468
In the page Line Settings-> IP Line Settings->FXS Gateway Management, if FXS
Gateway is added manually, the system can't recognize MAC address of FXS
Gateway entered in uppercase.
As a result the “Edit” and “Reboot” functional buttons become unusable and then
it is not possible to edit existing records or reboot the registered FXS Gateways.
Enter the MAC address in lowercase. Will be fixed in the next releases.
A problem with incoming Secure RTP call in a specific scenario 16533
When incoming Secure RTP call is connecting to the destination via Call Routing
table, Quadro always tries to connect it as an un-secure call and the call is being
dropped due to the media parameters incompatibility.
Will be fixed in the next releases.
An issue with wrongly displayed “Start Recording” message in the Active Calls
16184
The recording type is set to "start automatically"; the number of allowed parallel
call recordings is exhausted, therefore the recording for the next call cannot be
started, but the “Start Recording” is wrongly shown in the Active Calls page.
Will be fixed in the next releases.
Find me/follow me doesn’t work for incoming Secure RTP call 16683
Though the call came with SRTP option the FM/FM is making unsecure calls
As a result the call isn’t established
Will be fixed in the next releases.
ACD behavior becomes incorrect in case of troubles with 3pcc connection to an
application
Will be fixed in the next release.
The configuration page for Expansion Module is missing when configuring Yealink
T28 and T26 as receptionist phones 16971
In Receptionist Management wizard the Expansion module configuration pages
are not available for Yealink T28 and T26 phones.
Will be fixed in the next release.
An issue with Intercom service on snom 8xx phones 17282
When the snom phone of 8xx series (tested with snom phones 821, 870 running
FW version's 8.4.32, 8.4.33) have some watching configured for it's functional
keys and the status of the watching resource is changed (e.g. the watching
phone receives or makes a call), immediately the next intercom call to the snom
phone doesn't activate the intercom but continuously ring the phone.
As a result, if the calling phone is configured as a watched extension, the snom
phone never activates the intercom for that caller.
PAGE 19 10-Jul-13
Comments to this Manuals