Epygi Technologies Release Note QuadroM8L/26x/12Li/26xi 5.3.53, Edition 1
IP phone doesn't go back to the normally idle state automatically when the
recording had been started via the Record button and the call was released 15729
The "Recording started" message remains on the phone screen after one of the
parties terminate the call by going on-hook.
Only incoming calls to IP phone are possible in this state.
Need to use "Exit" button to retrieve the IP phone functionality. Will be fixed in the
future releases.
It is not impossible to pickup (via pickup group) the call to extension with
FindMe/FollowMe enabled 15942
Will be fixed in the next releases.
A problem with incoming Secure RTP call in a specific scenario 16533
When incoming Secure RTP call is connecting to the destination via Call Routing
table, Quadro always tries to connect it as an un-secure call and the call is being
dropped due to the media parameters incompatibility.
Will be fixed in the next releases.
An issue with wrongly displayed “Start Recording” message in the Active Calls
16184
The recording type is set to "start automatically"; the number of allowed parallel
call recordings is exhausted, therefore the recording for the next call cannot be
started, but the “Start Recording” is wrongly shown in the Active Calls page.
Will be fixed in the next releases.
Find me/follow me doesn’t work for incoming Secure RTP call 16683
Though the call came with SRTP option the FM/FM is making unsecure calls
As a result the call isn’t established
Will be fixed in the next releases.
The configuration page for Expansion Module is missing when configuring Yealink
T28 and T26 as receptionist phones 16971
In Receptionist Management wizard the Expansion module configuration pages
are not available for Yealink T28 and T26 phones.
Will be fixed in the next releases.
After changing Quadro LAN IP configuration (IP address or subnet mask) IP
phones lose registration and become unusable 16037
After changing Quadro LAN IP configuration first reboot the Quadro then reboot
the IP phones. Will be fixed in the next release.
An issue with Intercom service on snom 8xx phones 17282
When the snom phone of 8xx series (tested with snom phones 821, 870 running
FW version's 8.4.32, 8.4.33) have some watching configured for it's functional
keys and the status of the watching resource is changed (e.g. the watching
phone receives or makes a call), immediately the next intercom call to the snom
phone doesn't activate the intercom but continuously ring the phone.
As a result, if the calling phone is configured as a watched extension, the snom
phone never activates the intercom for that caller.
Will be fixed in some future FW release for snom.
Local authentication doesn’t work for a call scenario 16784
Local authentication configured in the Local AAA table by User Login or by PIN
code is ignored for the following call scenario; a SIP call to Quadro Auto
Attendant, then call to a SIP destination.
PAGE 19 10-Jul-13
Comments to this Manuals