Epygi Quadro Quadro M32x Troubleshooting Guide download pdf (Page 10)

Epygi Technologies Hidden Pages for Quadro Advanced Configuration

Figure 8 Extension Management page for extension 11

To edit any of the advanced settings using the Extensions Management page, click on the link

associated with the corresponding extension or attendant.

3.5 fxocfg.cgi

The Fxo Configuration page allows configuring the FXO port settings to match the

characteristics of PSTN lines (see Figure 9).

Please Note: All settings found on this page are automatically adjusted to the regional settings

set in the System Configuration Wizard. It is strongly recommended to leave the settings with

their default values unless the characteristics of a specific PSTN line differ from those predefined

for the region.

The following settings are found on the Fxo Configuration page (see Figure 9):

•

Custom Fxo Disconnect Settings: Enables the manual configuration of disconnect-call

detection settings. Central offices (COs) typically use any or a mixture of the following three

methods to notify call disconnection:

1. Disconnect notification by sending busy/disconnect tones. The CO sends specific

tones to notify that the call party has hung up. To configure the Quadro to detect

disconnect tones and close the call upon detection, enable the Busy Detection checkbox

and specify the following settings:

o Frequency 1: Frequency of the disconnect tone used by CO. If the CO sends dual tone

signals, enter the high frequency of the tone into the Frequency 1 text field and the

low frequency into the Frequency 2 text field. In case of single tone signals, set the

Frequency 2 to 0.

o Duration: Tone duration in ms.

o Duration Disp: Amount of time (ms) that the tone signal may vary from its assigned

value. It should be chosen reasonably large taking into account the value of Duration.

By default 100 ms is recommended.

o Silence and Silence Disp: Silence duration and the amount (in ms) that it may vary

respectively.

o Pattern Count: Number of tone(s)-silence patterns the system should identify as a

disconnect notification. Leave the factory default value if the exact number is

unavailable.

PAGE 10 17-Feb-15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

No comments

Epygi Quadro Quadro M32x Troubleshooting Guide Page 10